Set the volume and fade the sound
Lower the music in Effect Controls, drag a fade in on the clip, and solo a track to check it.
Playlist Editing basics
0 of 4 done
Music under a cut is usually too loud and starts too abruptly. This lesson lowers the score by 6 dB, fades it in over two seconds, and shows how to hear one track on its own.
Step 1 of 4
Select the music clip
Click track_day_score.wav on A1. With the Selection tool armed, two small white squares appear in its top corners: those are the fade handles, used in step 3.













Step 2 of 4
Lower its Level in Effect Controls
In Effect Controls, the Audio section has Volume with a Level in decibels. Click the value and type -6. That takes the music down enough to sit under the picture and leave room for voices.
Level has a stopwatch like any other property, so you can keyframe the music down under a voice and back up after it.


Step 3 of 4
Drag the fade handle to fade in
Drag the white square at the clip's top left to the right, about two seconds. A shaded ramp shows the fade. The top-right square does the same for a fade out. Drag a handle back to the corner to remove the fade.













Step 4 of 4
Solo a track to hear it alone
In the track header, S solos a track: only soloed tracks are heard, and the button turns blue. M mutes a track and turns yellow. Solo A1 to check the fade without the room tone on A2.













The music sits under the picture
Clip ▸ Audio Gain… adjusts the level before Volume, and the Audio Track Mixer panel (Window menu) has a fader per track for mixing while it plays.